Ways In Installing A Pocket Door Frame

A pocket door frame is often installed to conceal a certain door. This makes a certain room versatile enough and because it would simply be isolated to different areas of the house if possible. This can be a better way of maximizing the space of your living rooms. You can even accomplish it all by yourself if you are equipped with the right knowledge and patience as well. To aid you in the whole process, some effective tips are provided.

You must determine whether or not the wall that you have chosen is a good candidate for installation. The wall must be wide enough to accommodate two times the width of a door. You will also need to know if the wall is bearing too much load. You can know this by checking on the placement of the wall in your house.

You may as well check if there are any hidden pipes and electrical wiring that hides beneath it. Check also for some electrical outlets and switches just to be safe. Reroute the wires in other places such as the attic or the basement. You cannot position a certain frame in it if pipes are on the place.

Change the present header with the use of a saw that has a metallic blade that can cut through the nails to further remove the jamb. Take away all the pieces of board by using a blade that is designed for woods. Do it carefully to have a shallow cut. Utilize the part of the drywall which is over the door to make a frame for another header.

Remove the existing door by simply pulling it off from the molding. This will often create a certain gap which can be used to access the shims. Use a saw over the cluster of nails that is surrounding the shims. Always tip the blade of the saw downwards to cut shallowly into the drywall and take it away from the studs.

Leave a visible margin that is about two or three inches away from the ceiling upon removing the drywall from the header. A reciprocating saw is often used to remove such. You can also cut through the studs to form another space for the frame. See to it that you cut the nails that connects the studs to its soleplate.

Find out the dimension of the header and add about three to four inches to its length and add it further to the tallness of the soleplate. This is important most especially if you have a carpeted floor. Brackets can be placed to the floor simply if there are no carpets.

Cut the stud tops to a determined length to make a support for the new header. Measure its rough opening and place the new stud in it with the same distance in its opposite side. Install the new header by using the nails and screws and then cut and install the soleplate to the floor.

The whole installation process of your pocket door frame may be finished according to the manual that are set by the manufacturer. The header must be placed in level as well as the opening should be perpendicular to have it slide in a smooth manner. Trim screws may be used in the jamb to have it unnoticeable. You can also paint in to prevent having moisture that may destroy it.

Read more about Tips In Installing A Pocket Door Frame visiting our website.

Leave a Reply

Your email address will not be published.